We have been notified of numerous vehicle interactions involving heavy mobile plant equipment. Collision and struck-by incidents involving mining machines and other vehicles, objects, or people can result in fatalities or serious injuries.
What is the issue?
Our High Hazard Unit has recently been notified of numerous vehicle interactions involving heavy mobile plant equipment. Collision and struck-by incidents involving mining machines and other vehicles, objects, or people can result in fatalities or serious injuries. The bigger the mining machinery is, the harder it is for operators to see around them due to restricted visibility. This has been especially evident at surface mines with incidents involving large haul trucks.
How did these incidents happen?
Vehicle interaction incident one
A D10 bulldozer operator advancing a tip head noticed a soft area off ground that needed to be repaired to prevent dump trucks from getting stuck. The bulldozer operator manoeuvred his machine to repair the area by side-cutting the existing dumped material. While manoeuvring the bulldozer, a fully loaded 777 dump truck approached the tip site and positioned to unload. The bulldozer operator did not see the dump truck and reversed into the P1 wheel assembly deflating the tyre and causing structural damage.
Vehicle interaction incident two
During a night shift, a haul truck was approaching the right-hand side of a tip head while a bulldozer was working on the left-hand side. As the truck turned to line up with previously tipped load, the bulldozer operator decided to tram the vehicle over to previously dumped load to push it over the tip head. The bulldozer operator initially believed he would get there before the truck but once he realised he wouldn’t, and that he was in the path of the reversing truck, he tried to reverse out of the way. He was unable to warn the truck operator. The reversing truck clipped the corner of the bulldozer damaging the P6 tyre and rim.
Vehicle interaction incident three
A dump truck at an underground operation was reversing into a stockpile to be loaded by an underground loader loading waste rock out of the same stockpile. The loader operator misjudged the height needed to raise his bucket to allow the truck to reverse in for loading. This resulted in the loader bucket getting stuck on the tub of the underground truck. The loader operator was unable to alert the truck operator to stop reversing and the loader tipped onto its left hand side.
Two workshop personnel in a Light Vehicle were on their way to do maintenance in a mining pit area when they had to stop to avoid a 777B dump truck that went through a give way at an intersection. The truck came within metres of the Light Vehicle. The dump truck operator did not see the Light Vehicle until the truck was through the intersection, and was unaware that the Light Vehicle had had to stop to avoid collision.
Use of heavy machinery and moving objects in mines and quarries is a critical risk area which the sector needs to address through introducing effective controls and monitoring their effectiveness.
Controls for critical risks must be understood by all personnel and applied without exception to ensure everybody’s safety.
What can be learned from these incidents?
Mine operators should:
- utilise our Health and Safety at Opencast Mines, Alluvial Mines and Quarries guidelines to assist in development and implementation safe dumping methods and management tips for their respective Safety and Health Management System
- review relevant procedures and management plans to prevent vehicle interactions in dumping situations
- consult heavy vehicle operators on ways to prevent human error working at tip heads
- consider elimination or minimisation of interactions between heavy and light vehicles
- regularly inspect and observe critical risk activities to monitor and enforce compliance safe operating procedures
- carry out mobile plant visibility surveys to identify blind spot areas and put controls in place to correct them
- implement systems to help identify operating mobile plant locations around haul trucks (eg warning signage, elevated flag indicators with high-visibility strips, revolving light and having hazard lights on)
- design road intersections and dump areas to reduce mobile plant interactions
- design windrows for optimum visibility (eg at dump entrances)
- have managers and supervisors conduct adequate workplace inspections before and during work
- ensure personnel understand hazards and risks involved with mobile plant interaction.
We also strongly recommend mine operators investigate options of proximity detection systems for mobile plant used onsite such as:
- the proximity of detection/collision avoidance systems appropriate to the residual risk level, where reasonably practicable
- using Global Positioning Satellite (GPS) collision warning systems
- ultrasonic systems
- vehicle cameras.